![]() ![]() Shown here, the section of drywall that remains is on the right the portion to be removed is on the left. Be sure to cut the inner portion so that the adjacent section of drywall is still fastened to the joist. Cut a new piece of paper drywall tape and place it in the space where the old tape was. If the section of drywall bridges a joist, but you only want one side of the drywall removed, cut with your saw alongside the joist.After the joint compound breaks away, cut through the embedded tape with a utility knife. If you are removing a section of drywall with an edge that hits the bottom of a joist, you can pull straight downward-it should separate from the adjacent section of drywall at the joint.If accessing from below, punch into the center of the drywall with a drywall saw or reciprocating saw and slice away strips until you meet a stud. ![]() To do so successfully, follow these suggestions: Removing drywall without damaging adjacent areas is difficult, and there is no one way to go about it. Outline your planned "cut edges" with painter's tape. Take note of these hanging edges because they will not be picked up by the stud finder.īelow the ceiling, identify places where the drywall is attached to joists by using a stud finder. The edges of the drywall will be attached to ceiling joists, although you may encounter some hanging edges supported by a strip of drywall that bridges to the adjoining sheet. The loose tape can look like a bubble in more serious cases, youll see drywall Sheetrock tape start to separate from the drywall completely and start to. Make sure there are no wires or pipes in the area where you will cut out the old drywall. With the area clear, you can see the perimeter of the drywall to be removed. The Spruce Home Improvement Review Board. ![]()
0 Comments
Leave a Reply. |